|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Regulations BACK to VIRTUAL TOUR The following fact sheet was prepared by the ECAR Center staff. Once prepared, each ECAR Center fact sheet undergoes a review process with the applicable state environmental agency(ies). You can check on the status of the review process here. Please read the disclaimer on the status page. While we have tried to present a summary of the essential information on this topic, you should be aware that other items, such as local regulations, may apply to you. What You Need to Know To dispose of used oil filters, you need to drain out the used oil thoroughly first. The oil can then be handled with the rest of your used oil (see the ECAR Used Oil Fact Sheet). If correct management procedures are followed, used oil filters can be either recycled or disposed of. However, recycling is the better choice. Non-terne plated used oil filters are not hazardous waste and can be disposed of as general refuse if they are properly drained. Terne is an alloy of tin and lead. Terne-plated filters may be hazardous waste because of their lead content. If you generate terne-plated filters, they may be subject to testing and other hazardous waste determination requirements. Draining used oil from your filters can be performed using one of the following methods:
Also, keep in mind that "hot-drained" means draining the oil filters at temperatures near the operating temperature of the engine, not draining at room temperature. A minimum of 12 hours draining time is required for proper hot-draining. Filters that immediately drip oil when picked up are not considered drained. *Used oil drained from filters can be combined with other used oil. Used oil filters that are not drained by the above methods must be managed as hazardous waste. Fuel filters also are considered hazardous waste and must be managed accordingly. Disposal. If the above methods have been performed, used oil filters can be disposed of according to town and county requirements. The drained filters should be placed in covered dumpsters or containers that prevent rain infiltration. In addition, the dumpsters or containers should be capable of holding any residual used oil that may escape from the filter. Spill Control. If an oil spill occurs as a result of draining or handling used oil filters, you must perform the following cleanup steps:
Links to the Regulations. Use the following links to view the regulations pertaining to used oil filter management. Kansas’s Used Oil Management Requirements (28-31-16) Federal EPA Used Oil Management Requirements When
an inspector comes to your facility, there are certain things he
or she checks to see if you are in compliance with environmental
regulations. It makes good sense for you to perform a “self-audit”
and catch and correct problems before they result in penalties.
Also, there are some compliance incentives associated with self-audits
(see Audit Policy Page).
Use
the following list to audit your used oil filter management procedures. Most
regulations tell you what you have to do to be in compliance, but
they don’t explain how to do it. That’s where “best management
practices” come into play. BMPs are proven methods that help
you to get into compliance and stay there. The following BMPs are
recommended for used oil filter management.
BACK
to VIRTUAL TOUR |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
