ECAR Fact Sheet for Connecticut
Vehicle Crusher

Regulations
Self-Audit Checklist
Best Management Practices
Contacts
Related ECAR Fact Sheets
Other Relevant Resources

BACK to VIRTUAL TOUR

The following fact sheet was prepared by the ECAR Center staff. Once prepared, each ECAR Center fact sheet undergoes a review process with the applicable state environmental agency(ies). You can check on the status of the review process here. Please read the disclaimer on the status page. While we have tried to present a summary of the essential information on this topic, you should be aware that other items, such as local regulations, may apply to you.

What You Need to Know

The main environmental concern in vehicle crushing operations is letting any fluids still in the vehicle get away from you.  If fluids are allowed to drain into the soil, or to get into a drain where they are not supposed to be, you could be in for trouble.  And even if the fluids are contained in the crushing area, you need to be sure stormwater won't wash them away.

If the fluids are hazardous wastes, special handling and disposal rules will apply to them.

The Connecticut Department of Environmental Protection (CT-DEP) has prepared a guidance document to help auto recyclers manage vehicle crushing activities. Much of that information is included in the fact sheet below. You can access the link to CT-DEP's Auto Recycling Guide under Other Relevant Resources.

Regulations

There are no environmental regulations that specifically govern the design and operation of vehicle crushing operations. However, if vehicle crushing is not performed properly, vehicle fluids will drain to the soil, which is prohibited. Also, allowing vehicle fluids to be carried away by stormwater is prohibited. Therefore, auto-recycling facilities should implement the best management practices listed below to help prevent these types of environmental violations from occurring at their vehicle crushing operations.

An additional environmental concern is the potential air emissions from vehicle crushers. If the crusher is powered by a fuel burning engine, either to generate electricity or power hydraulic systems, an air permit may be needed or additional regulatory requirements may apply.

If you have a stationary crusher, you may need stormwater, wastewater discharge or air pollution control permits. Contact the Connecticut Bureau of Water Management to see if water permits are required for your site and contact the Connecticut Bureau of Air Management to see if a permit is required for the emissions at your site.

Fluids collected during oil crushing operations should be managed as hazardous waste unless a hazardous waste determination has been made that proves that the fluids are non-hazardous. A hazardous waste determination involves collecting samples of the fluid and having the samples analyzed at a laboratory.

Links to the Regulations. Use the following links to view the regulations pertaining to hazardous waste determinations and management.

Connecticut Hazardous Waste Regulations

Federal EPA Standards Applicable to Generators of Hazardous Waste

Self-Audit Checklist

When an inspector comes to your facility, there are certain things he or she checks to see if you are in compliance with environmental regulations. It makes good sense for you to perform a "self-audit" and catch and correct problems before they result in penalties. Also, there are some compliance incentives associated with self-audits (see Audit Policy Page).

Use the following list to audit your vehicle crusher management procedures.

1. Do vehicle fluids escape to the soil from vehicle crushing operations? Verify that the soil surrounding vehicle crushing operations does not show signs of vehicle fluid spills. If there are signs of fluid spills, such as stained soil or dead vegetation, then remediation may be necessary.
2. Are fluids generated from vehicle crushing properly managed and disposed of? Verify that fluids were properly managed and disposed/recycled as hazardous waste or that a hazardous waste determination was made that indicates it is a non-hazardous waste. If the waste is non-hazardous, verify that it is properly managed.

Best Management Practices (BMPs)

Most regulations tell you what you have to do to be in compliance, but they don't explain how to do it. That's where "best management practices" come into play. BMPs are proven methods that help you to get into compliance and stay there. The following BMPs are recommended for vehicle crusher management procedures.

• Vehicles should be adequately drained prior to crushing in order to minimize the volume of waste fluids to manage. Fluids such as fuel, used oil, transmission fluid, antifreeze, etc. should be stored in separate containers that are clearly labeled.
• Vehicle crushers should be situated on a bermed or self-contained impervious surface, preferably under a roof and protected from the weather. The floor surface should be sloped to contain fluids. Position crushers toward the center of the surface or concrete pad rather than along the edge.
• Mobile crushers should always be situated on an impervious surface or heavy duty plastic sheeting. Containers designed to be fitted to the crusher can help capture fluids.
• Maintain disposal receipts from mobile crusher operators for all wastes generated and transported off-site for disposal.

Contacts

1. For more information, contact the Connecticut Bureau of Waste Management at 860-424-3021. If you have a stationary crusher, you may need stormwater, wastewater discharge or air pollution control permits. Contact the Bureau of Water Management at 860-424-3018 to see if water permits are required for your site and contact the Bureau of Air Management at 860-424-3027 to see if a permit is required for the emissions at your site.
2. To report a spill or leak, immediately call the Connecticut Department of Environmental Protection, Oil and Chemical Response Division at 860-424-3338, 24 hours/day.  Should this number become unavailable for any reason, call 860-424-3333. Within 24 hours of the spill you are required to complete a written Report of Petroleum or Chemical Product Discharge.
3. To report an environmental incident or complaint, contact the nearest regional office.

Related ECAR Fact Sheets

1. Hazardous Wastes

Other Relevant Resources

1. Connecticut Auto Recycling Guide

BACK to VIRTUAL TOUR