ECAR Fact Sheet for Arkansas
Floor Drains
Regulations
Self-Audit Checklist
Best Management Practices
Contacts
Related ECAR Fact Sheets
Other Relevant Resources
The
following
fact sheet was prepared by the ECAR Center staff. Once prepared,
each ECAR Center fact sheet undergoes a review process with the
applicable state environmental agency(ies). You can check on the
status of the review process here.
Please read the disclaimer on the status page. While we have tried
to present a summary of the essential information on this topic,
you should be aware that other items, such as local regulations,
may apply to you.
BACK
to VIRTUAL TOUR
What You Need to Know
Floor
drains, especially those built when designers and contractors were
much less environmentally conscious than they are now, can be full
of surprises. If you do not know what is happening at the
other end of yours, you would be well advised to find out before
an inspector does.
Floor
drains in many industrial facilities have been found to empty into
surface waters, or into septic fields. The discharge of wastewater
from the shop floor into septic fields is illegal, and you must
have a permit to discharge into any water of the state. If
the floor drain discharges into a city sewer system, it will also
need a permit, and will need to be periodically monitored.
Floor drains can also leak, and have been known to cause serious
and costly soil and groundwater contamination problems. This
fact sheet will help you determine if the floor drains in your facility
are properly connected and properly used.
Regulations
This
fact sheet addresses regulatory issues and practices associated
with floor drain systems. A floor drain system commonly includes
a concrete trench, which runs down the center of a shop floor that
may lead to underground pipes and/or tanks. Instead of a trench,
some shops have single or multiple rectangular or round floor drains.
Typically, the shops floor is slightly sloped to allow liquids to
flow into the floor drain.
A
floor drain is a red flag for any inspector from an environmental
protection agency. Their concerns are primarily:
- What types of materials could potentially enter the
floor drain system, and
- What ultimately happens to those materials?
It
is very important to know where all your floor drains lead, and
are aware of the Arkansas Department of Environmental Quality (DEQ)
regulations that apply to your discharge activities. If you do not
know where your drains lead, or if you using floor drains improperly,
you could be contaminating nearby surface waters or drinking waters.
Some
floor drains lead into a sanitary sewer, where wastewater goes directly
to a sewer system or treatment plant. Sometimes floor drains lead
directly to an underground holding tank or discharge to a waterway
or to the ground outside. DEQ's water pollution control regulations
apply to all of these activities.
If
you want to discharge process wastewater to waters of the state,
you must have a National Pollutant Discharge
Elimination System (NPDES) permit from DEQ. Examples of waters
of the state include streams, rivers, lakes, ponds, marshes, waterways,
wells and springs. If your floor drains lead to any water of the
state, you must have a discharge permit for this activity.
Companies
that discharge process wastewater directly to a sewer system or
treatment plant are also regulated. Check with your local sewer
authority to determine whether you need a permit. In addition, you
may be required to treat the wastewater before discharging (e.g.
oil/water separation, removing solids, chemicals, etc.).
Note:
It is illegal to discharge process wastewater outside your business
into a septic tank or dry well. See the ECAR Septic Tanks Fact Sheet.
Links
to the Regulations and Forms. Use the following links to view
the regulations and permit forms pertaining to floor drains.
NPDES
Permit for Industrial Wastewater Discharges
Arkansas Water Quality Standards (Regulation 2)
Federal Rules for
Class V Wells
Federal Rules for
Motor Vehicle Waste Disposal Wells
Self-Audit
Checklist
When
an inspector comes to your facility, there are certain things he
or she checks to see if you are in compliance with environmental
regulations. It makes good sense for you to perform a "self-audit"
and catch and correct problems before they result in penalties.
Also, there are some compliance incentives associated with self-audits
(see Audit
Policy Page).
Use
the following list to audit your floor drain system.
- Do your floor drains discharge to the ground,
a water body or storm sewer? Are the discharges authorized by
a permit? If you are using floor drains to discharge
process wastewater to a water body you must have a National Pollutant
Discharge Elimination System (NPDES) Permit. This includes discharges
into storm sewers. In
some areas of the state, such as those over sole source aquifers,
discharge to ground may not be allowed or may require further
controls.
- Do your floor drains discharge to a city sewer
system? Are the discharges authorized by a permit? If you are using floor drains
to discharge wastewater to a local wastewater treatment plant,
make sure the treatment plant knows about this activity. You may
be required to conduct treatment on the wastewater before discharging
it. You also will need to get a permit or written notification
for the discharge.
- Is oil or solvent discharged to floor drains? These are RCRA regulated wastes
and must be removed and properly disposed of. If the floor drain
system is connected to the city sewer system, Federal and state
laws prohibit the discharge of oil or flammable solvents.
- Is your floor drain connected to a septic tank
or dry well? If so, you are in violation
of state law. All septic tanks and dry wells must be sealed or
closed.
Best
Management Practices (BMPs)
Most
regulations tell you what you have to do to be in compliance,
but they don't explain how to do it. That's where "best
management practices" come into play. BMPs are proven
methods that help you to get into compliance and stay there. The
following BMPs are recommended for floor drains.
- Check all of your floor drains and make sure you know
where they drain.
- Cap or plug floor drains that are not serving a useful
and lawful purpose.
- Use drip pans or similar devices to collect vehicle
fluids before they reach the floor drain system.
- Do not put fluids like oil, solvents, paints or chemicals
into a floor drain.
- Install berms in the shop around areas where chemicals
are stored to prevent their entry into the floor drain system.
- Install screens in drains to prevent solids from entering
the floor drain system.
- Develop and implement a maintenance schedule for inspecting
and cleaning the floor drain system.
- Prepare and train for emergencies. Have a plan in place
to quickly cleanup a spill before it escapes.
- Use dry cleaning methods such as sweeping instead of
water cleanup, whenever possible.
- Don't hose down your work area. This practice generates
large quantities of contaminated wash water.
- Consider sealing your shop floor with epoxy or other
suitable sealant.
Contacts
- For more information, Arkansas Department of Environmental
Quality (ADEQ), Water Division
at 501-682-0654.
- Report any spill of used oil or fuel that discharges
to a water body, or any spill over 25 gallons, to the National
Response Center at 1-800-424-8802 and the Arkansas Department
of Emergency Management at 1-800-322-4012
- To report an environmental incident or complaint,
call 800-327-8411 or 800-EARTH-11.
Related
ECAR Fact Sheets
- Wastewater
- Septic
Tanks and Disposal Wells
- Stormwater
Other
Relevant Resources
- Environmental
Compliance Guidance for Arkansas Auto Dismantlers
- Managing
Floor Drains and Flammable Traps, Minnesota Pollution Control
Agency
BACK
to VIRTUAL TOUR
|